I'm someone who solves problems by looking, not asking. So this is new to me. This has been an issue for years, and it crops up with different computers, networks, versions and completely different code. There is a lot here, so, thank you in advance if you are willing to read the whole thing. Generally speaking, I write MS Access programs that will open Excel and then create multiple worksheets inside of a workbook using data from Access tables and/or Excel sheets. The process can take a couple of minutes to run and occasionally, it will get an error. I could tell you the error message, but it doesn't matter because it will be different depending where the error occurs. When it occurs I simply click debug and click continue and it... continues. If it errors out again (many loops later), it will happen in the exact same spot.
So, what I start with is to make minor changes to the code. In the current program I'm working on, the error happens when I write to a cell and the value is a value directly from a table. I created a variable, copied the value to the variable and then wrote to the cell. The error moved to a completely different part of the program and it became a "paste" error. Generally what fixes it is to put a wait function at the spot where the error occurs. One second is usually good enough. Sometimes it takes a couple of these, but that usually solves it. It only took one delay per loop this time, so it is working. I just hate causing delays in my program. So... Has anyone seen anything like this before, or is it just me. It feels like a timing issue between Access and Excel since the delays are usually helpful. Thanks in advance.